Thread starter Jalps Start date Dec 27,
Jul 20, Most stump jumpers are seated on a tapered and splined shaft. By the shaft being tapered and seated the stump jumper is usually not going to just drop off after the bolt is removed. It always takes some hammering (big hammer) and some heat from a propane torch for me to remove them. Quick heat around the shaft. May 02, Lay out the center of the stump jumper and then drill and tap a 3/4 inch fine thread hole and wind a grade 8 bolt in and maybe it will free the stump jumper.
The hole must go through the stump jumper so the bolt pushes on the gearbox treegrinding.barted Reading Time: 4 mins.
I haven't bought parts yet as I want to bring in the old ones but a new bolt and nut kit was part of the plan from the start.
Aug 31, Loosen the bolt holding the stump jumper to the splined shaft. Start tractor and engage PTO for a second. The sudden jar is usually enough to loosen the stump jumper. 40HP Rotary Cutter Stump Jumper Fits 4 ft., 5 ft. and 6 ft. Rotary Cutters Genuine King Kutter Replacement Part /8 In diameter at top View all of our King Kutter rotary cutter parts along with an exploded diagram for easy identification and treegrinding.bar: King Kutter.
STUMP JUMPER 60HP. Dear customer: Due to a high volume of orders and disruption in the supply chain, King Kutter Inc. is experiencing extended lead times on all orders. The innovative 30” diameter head engages a large area of the stump simultaneously. It drastically reduces the amount of time it takes to remove a stump and therefore increases productivity. In fact it can take a 30” diameter stump and cut it down 18” in less than. STUMP JUMPER 40HP. Dear customer: Due to a high volume of orders and disruption in the supply chain, King Kutter Inc.
is experiencing extended lead times on all treegrinding.barg: removal. Jul 31, I've worked on a few older King Kutter bush hogs, blade changing can take on a life of it's own! It would be useful to understand which model you are working on, are you trying to remove the bolt that holds the blade to the stump jumper?
Is the bolt threaded into the stump jumper or do you have a castle nut on the back (top) of the stump jumper?